Rongcheng Wujia Plastic Co.,Ltd
Tel:+8615098125996
peter@wujiapack.com
Home > Exhibition > Content
Product Categories
Contact Us

Rongcheng Wujia Plastic Co.,Ltd

Office Address: 81 Huize St, Heyang East Road, Rongcheng, Shandong, China

Factory Address: 81 Huize St, Heyang East Road, Rongcheng, Shandong, China

Contacts: PETER WU

Phone: 86-15098125996

Fax: 86-0631-7584439

E-mail: peter@wujiapack.com

Zip code: 264300

Exhibition

How ziplock ziplock film blowing machine manufacturers should care

Rongcheng Wujia Plastic Co.,Ltd | Updated: May 26, 2016

First, check the integrity of temperature-controlled heater element intact, each point temperature is in the range of indicators

Second, check the operation of the motor current, speed, temperature, precision, noise and mechanical transmission whether standard, check the oil level and mechanical gearbox lubrication.

Third, the battlefield pulling speed, film width, thickness control is accurate.

Fourth, the film thickness were observed leveling. Fold Path compliance with standards.

Fifth, check the control ratio of raw materials, the mix of compliance with standards.

Sixth, the film was observed plastics, and found that grain, stiff block, waterlines timely manner.

VII, check the air storage cylinder pressure is operated in compliance with the requirements, clean the oil-water separator

Eight, periodic calibration die, traction, the midpoint of the guide roller, the level of degree, degree of balance.


Rongcheng Wujia Plastic Co.,Ltd